如何修改FLEX刀箱中以太网交换模块的CLI方式为：iscli或ibmnos-cli

知识点分析:

ibmnos-cli：一种老式的菜单命令行

iscli：大致 90% 以上的命令与 Cisco的相同或相似

以下操作请在未进行过配置的机器中操作。

操作步骤:

1、从ibmnos-cli模式进入到iscli模式

 

>> Main# boot

--------------------

[Boot Options Menu]

     sched     - Scheduled Switch Reset Menu

     image     - Select software image to use on next boot

     conf      - Select config block to use on next boot

     netboot   - NetBoot and NetConfig menu

     mode      - Select CLI mode to use on next boot

     prompt    - Prompt for selectable CLI mode

     gtimg     - Download new software image via SFTP/FTP/TFTP

     ptimg     - Upload selected software image via SFTP/FTP/TFTP

     reset     - Reset switch [WARNING: Restarts Spanning Tree]

     cur       - Display current boot options

 

>> Boot Options# mode

Currently set to use switch mode "ibmnos-cli" on next boot.

Specify new mode to use ["ibmnos-cli"/"iscli"]: iscli

Next boot will use mode "iscli".

 

重启交换机

Boot Options# reset

WARNING: There are unsaved configuration changes.

Confirm operation without saving changes (leave them pending) [y/n]: y

 

Reset will use software "image1" and the factory default config block.

>> Note that this will RESTART the Spanning Tree,

>> which will likely cause an interruption in network service.

Confirm reset [y/n]: y

Resetting at  2:28:11 Fri Aug 26, 2016...

 

2、从iscli模式进入到ibmnos-cli模式

Router>enable

Router#configure terminal

Router(config)#boot cli-mode ibmnos-cli

Next boot will use mode "ibmnos-cli".

Router(config)#reload

WARNING: The running-config is different to startup-config.

Confirm operation without saving running-config to startup-config (y/n) ? y

Reset will use software "image1" and the factory default config block.

>> Note that this will RESTART the Spanning Tree,

>> which will likely cause an interruption in network service.

Confirm reload (y/n) ? y

Resetting at  2:19:31 Fri Aug 26, 2016...